Pool resurfacing in Pine Ridge: three soil samples, three drain plans
Find Pine Ridge in the northwest corner of Collier County, east of Pelican Bay and north of Naples, and you're looking at 1.8 square miles of North Naples. The area is small, yet the dirt changes from one spot to the next. Soil lookups at three points turned up three map units: Satellite fine sand with urban land, Immokalee fine sand with urban land, and a Holopaw and Basinger mix with urban land.
Drainage splits the same way: Satellite rates somewhat poorly drained, while Immokalee, Holopaw and Basinger rate poorly drained. The USDA description of Immokalee fine sand puts the seasonal high water table within 6 to 18 inches of the surface for one to four months in most years. Then there's urban land, 25 to 40 percent of each unit, which is ground someone built on and reshaped. No soil name will tell you what's under your lanai.
Why bother? An empty shell has wet ground pressing against it with nothing inside to resist. Where a water table is anticipated, an approved hydrostatic relief device is required under the Florida Building Code (R4501.21.4). Our job is to find yours, test it and lower the water step by step. The drain plan follows your street's ground.
Zone X on all three lookups, and the Collier route that still applies
FEMA's map read Zone X at all three spots looked up in Pine Ridge, an area of minimal flood hazard. A point on a map isn't a ruling on your lot, though. Look up your own address on FEMA's National Flood Hazard Layer and show us what it says when we walk the shell.
Your permit desk here is Collier County Growth Management, since Pine Ridge is unincorporated. Its pool permit page carries a "Resurfacing Pool" entry in the online portal, and the application asks if the declared value of the work is more than 25 percent of the structure's improved value. Collier also offers a letter of exemption for qualifying work valued under $7,500, available from July 1, 2026. It applies to single-family detached homes alone. No structural, mechanical, electrical, plumbing or gas work may be added, and flood hazard areas don't qualify. Price your job over $7,500 and you're outside it, and the county says you can't split a project to slip under the limit.
We ask the desk which path fits your pool refinishing scope before we put a price on it. Our permit guide compares Collier with the City of Naples and Lee County.
What we mark on a Pine Ridge shell before we quote
Drag your palm across the plaster. A rough spot, a stain that won't scrub out, a chalky patch or bare gunite at the waterline each says the finish is spent, and we flag every one on our walk of the shell. Resurfacing also puts three other parts in front of us: the waterline tile, the coping and the drain cover. With the shell empty and dry anyway, tile and coping repairs get their own lines on the estimate rather than hiding inside the finish price.
The code asks for entrapment protection on suction outlets (R4501.6.6, ANSI/PHTA/ICC 7), and a cover is easiest to read with the water out. We check it then and tell you what we find.
You can help before we arrive. Take daylight photos with your hand in the frame for scale. Write down what you know about the last finish: year, material, any patch work. If the pool loses water, say so up front, because that changes the plan before it changes the price.
Plaster, quartz or pebble: picking a finish before the water comes out
Material sets the price: plaster sits at the bottom, quartz and pebble in the middle, and glass bead or a big shell at the top. A Southwest Florida resurface typically costs $6,000 to $16,000. Glass bead or a large pool costs $14,000 to $20,000. The finishes guide lays all four out together. Have us bring samples and wet them. A dry chip tells you little about the color you'll see underwater.
Got a homeowners' association on your street? Get its written guidelines before you pick. Florida law (F.S. 720.3035) limits an association's architectural review to what its documents state or reasonably imply. Where the documents give options for materials, size, design or location, the association can't restrict your right to choose among them. Reading your documents isn't our job. Writing down the exact finish and color you want is, so the board has something specific to answer.
Book pool resurfacing in Pine Ridge with a price in writing
Ready for pool resurfacing in Pine Ridge? Call (239) 899-6371 or send a note through the contact page for a free walk-through. One written estimate follows, naming the finish, the tile and coping scope, the drain route and the price, all before any work begins. A tracked storm moves the drain date, since the Atlantic hurricane season runs June 1 to November 30.
See the whole job on the pool resurfacing page, read about the Pine Ridge area, or ask what a bigger scope would cost on the Pine Ridge renovation page.
Sources
- Pool (PRSPL) permit requirements, Collier County Growth Management
- Certain qualifying work under $7,500 exempt from building permits, Collier County Building Division
- Immokalee series official description, USDA NRCS
- Florida Building Code, Residential, Section R4501, ICC Florida Building Code text via UpCodes
- National Flood Hazard Layer, FEMA
- F.S. 720.3035 Architectural control covenants, Florida Legislature
- F.S. 713.13 Notice of commencement, Florida Legislature
- Tropical Cyclone Climatology, NOAA National Hurricane Center
- Pine Ridge, Collier County, Florida, Wikipedia




