The screen enclosure hurricane code in Naples, one input at a time
You never buy a wind rule. You buy a cage, and the rules explain why your neighbor's drawing looks different from yours. Florida puts them in Chapter 20 of the Florida Building Code, Building volume, in a short section aimed at screened enclosures. Four inputs feed it: the design wind speed at your address, the exposure category of your lot, how tall the cage stands and what mesh is in the walls. Move any one and the engineer's loads move too.
We'll take them in the engineer's order, then the panels, the permits and the post-storm call. Our screen enclosures page covers the build and the price; this guide is the rulebook behind it. The sealed drawing and the permit office for your address still have the last word.
Where your design wind speed comes from: Collier's 150 mph floor
A cage drawing carries an ultimate design speed, written Vult. It's a number engineers load a structure against, and it says nothing about what a given storm will do. Collier County puts its minimum at Vult 150 mph for a Category II structure, and the Wind Zone Map adopted by the Board of County Commissioners takes it as high as 170 mph in some regions. Category II covers an ordinary house.
Here's the part cage quotes skip. The code's risk category table (Table 1604.5) lists screen enclosures in Risk Category I, the low-hazard group, and Chapter 16 sends their wind loads to Section 2002.4. So the speed on a cage drawing is read for that category at your address, not copied off the house plans. The engineer picks it and the permit reviewer checks it. Ask to see the number on the sheet.
Neighboring offices read the same state book. The City of Punta Gorda says it enforces the 8th Edition (2023) Florida Building Code with no local amendments, and Charlotte County's pool permit review covers wind and flood loads. Lee County runs its own desk. On a Lee address we ask the county for the speed before anyone sketches a frame.
Hurricane season runs June 1 to November 30 and peaks around September 10. (National Hurricane Center). Ian in 2022 did an estimated $989 million in damage in the City of Naples and knocked out power for days. A drawing sets the floor a frame is built to. It can't promise anything about one storm.
Exposure B, C or D: why one cage can carry three different loads
Exposure is the code's question about what the wind crosses on its way to your lanai. Section 1609.4 of the 2023 Florida Building Code grades the ground upwind in three roughness types. B is urban, suburban or wooded ground with lots of closely spaced obstructions the size of a house or bigger. C is open terrain with scattered obstructions mostly under 30 feet. D is flat, unobstructed ground and water surfaces.
A structure with a mean roof height of 30 feet or less gets exposure B when roughness B holds for at least 1,500 feet upwind. It gets D when roughness D runs at least 5,000 feet upwind (or 20 times the height, if greater), or when the site sits within 600 feet of a stretch like that. Everything else is C. The screen enclosure table then prices each in pressure. At 150 mph, the windward push is 31 psf in B, 43 in C and 51 in D.
| Design wind speed | Exposure B | Exposure C | Exposure D |
|---|---|---|---|
| 150 mph, windward face | 31 psf | 43 psf | 51 psf |
| 160 mph, windward face | 36 psf | 49 psf | 58 psf |
| 170 mph, windward face | 40 psf | 56 psf | 66 psf |
Water matters here. 25.09 percent of the City of Naples' 16.4 square miles is water. Port Royal was dredged from Naples Bay marsh in the early 1950s, and Aqualane Shores, Park Shore and the Moorings followed. Whether the open water upwind of your lot is long enough to count as a D stretch is a measurement, not a guess. We don't call it from the street. The engineer reads your survey and aerials, and the permit reviewer double-checks.
Height, mesh and roof panels: the adjustments printed on the drawing
The table assumes a mean roof height of 30 feet. Other heights scale the pressures with the factors in Table 2002.4A. At 15 feet or less the factor is 0.81 in exposure B, 0.86 in C and 0.89 in D; at 60 feet it climbs to 1.22, 1.16 and 1.13.
Mesh adjusts the numbers next. The table pressures assume 20 by 20 by 0.013 inch screen. Switch to a coarser 18 by 14 by 0.013 inch screen and you may multiply screen-surface pressures by 0.88. Go denser than 20 by 20 and the designer has to use the heavier enclosed-building pressures. Offered tighter mesh for bugs? Ask if the drawing assumed it.
Solid roof sections come third. A hard panel isn't screen, so it's designed for component and cladding loads. A Collier application with panel roofing must list the Florida Product Approval or Miami-Dade NOA numbers (Collier's aluminum structure page).
The frame has its own minimums. Extruded members need an actual wall of at least 0.040 inch. Each main member carries a 300-pound load on any 1 foot, and purlins 200 pounds, with that gravity load figured apart from the wind. The book also accepts the AAF Guide to Aluminum Construction in High Wind Areas as sound engineering practice.
Removable panels, the 75 mph decal and who pulls them
Some cage walls aren't screen. Where yours has vinyl, tempered glass or acrylic, each panel has to come out and wear a decal. The code asks for a decal that says, in substance: "Removable panel SHALL be removed when wind speeds exceed 75 mph." It has to be readable with the panel in place. Walk out and look at yours.
Why pull them so far below the frame's design speed? A solid panel catches wind that mesh lets through. Table 2002.4 shows the gap: at 150 mph in exposure C, the vertical push on screen surfaces is 12 psf and on solid surfaces 45 psf. Take them out well ahead of a storm, long before the first rain band appears on radar.
Who does the pulling is a household question, and Naples makes it a bigger one. The 2020 Census counted 46.1 percent of the city's 18,225 housing units as vacant, and plenty of those are seasonal homes. Leave in April and the season still runs to November 30, so put a name in writing: a neighbor, a property manager, anyone who can get in the gate. Ask your builder for a written list of how many panels you have, where they are and where to store them.
Cage permits are separate, and each office files them its own way
In Collier County the pool and the cage are two permit types. The county calls the cage an Aluminum Structure permit, or PRAS. It wants construction plans, signed and sealed where they apply, plus a site plan to the county's Bulletin 21, certified once new impervious area tops 400 sq ft. At final, the county asks for a spot survey with a note identifying the screen-enclosed pool area. That packet is where the screen enclosure hurricane code in Naples meets the county's review.
- City of Naples: the city's pool checklist says accessory structures, screen enclosures included, are permitted separately, and every application goes in electronically through the city's public portal.
- Lee County: every pool must be enclosed by a fence, wall, screen enclosure or similar structure. The enclosure takes a separate permit, and the barrier has to be in place by final inspection.
- Marco Island: a permit and an inspection are required for screen enclosures that act as pool barriers.
- Estero: the Village lists a lanai or pool cage as work that needs a permit.
- Punta Gorda: its fee schedule lists $200 for aluminum structures and cages, and charges four times the fee if work begins without a permit.
Offices change forms and fees, so use that list as a starting map and not a promise. If the cage and the pool are one job, we pull both permits together. The pool permits guide lays out the full packet for each county.
After a storm: rescreen, repair or rebuild the frame
Torn mesh is cheap to fix. A bent beam is another story. Check three things: is the aluminum straight, are the anchors tight, and did only the screen fail? If yes, a rescreen runs $3 to $6 per sq ft, or $5,400 to $10,800 on an 1,800 sq ft cage. If beams are bowed, fasteners have pulled or whole sections have racked, you're into new frame work at $9 to $16 per sq ft, which is $16,200 to $28,800 on that same cage. Those are our typical ranges. Your free written estimate comes after we see the cage.
A new frame goes in on a new permit and drawing, so its wind speed and exposure get checked again under the code in force when you apply.
Two permit points show up after a storm. Collier says it prioritizes building permits that address hurricane damage, and you can apply in person or through its CityView portal. FEMA's 50 percent rule, in 44 CFR 59.1, applies when repair or improvement cost reaches 50 percent of a structure's market value before the work, so a badly hit house can raise floodplain questions. Ask the floodplain desk before you sign.
Does a plain rescreen need a permit? Each office decides. Collier's exemption list covers enclosing an existing covered patio with screening, which isn't the same job. Call the office, or let us ask for you.
Does the cage double as your pool barrier?
Yes, it can. Section R4501.17.1.11 of the residential pool barrier rules lets a standard screen enclosure that meets it serve as part or all of the barrier, and lets the enclosure stand as close to the water's edge as the book allows. Behind it sits the state's pool safety law, Florida Statutes chapter 515, which requires a new residential pool to meet at least one safety feature option before final inspection.
The wind rules tie in. Section 2002.7 lets an engineer design an all-screen cage on the assumption that marked panels get removed, retracted or cut, and screen marked to be cut must be cut completely when winds are forecast above 75 mph. That route needs signed and sealed site-specific engineering. If that cage is also your barrier, the code says the barrier's minimum height has to hold with those panels out. Ask whether your drawing uses it. Your permit office will say which option it approved for your pool. We don't give legal advice.
Questions to put to any pool cage builder before you sign
- What design wind speed is on the drawing, and which map or office told you?
- Which exposure category did the engineer use for my lot, and why?
- What is the mean roof height, and which height factor was applied?
- Which mesh does the drawing assume, and is that the mesh in the estimate?
- Are there removable panels, how many, and is the 75 mph decal on each?
- Who files the cage permit, and is the final spot survey in the price?
Get each answer in writing. Our free written estimate answers all six before any work starts.
Get the screen enclosure hurricane code in Naples read against your address
Send us your address and a few photos of the lanai. Naples Swimming Pool Construction Co checks the design wind speed, tells you which exposure the lot probably falls under, and prices the cage or the rescreen in writing before work begins. When a cage and a pool go together, one crew files both permits. We're Fully Insured. The screen enclosure hurricane code in Naples reads the same for every builder in Collier, so compare the drawing and the paperwork behind each number. Call (239) 899-6371 or use the contact page for a free estimate, or start with our new pool construction and pool renovation pages if the cage belongs to a bigger job.
Sources
- 2023 Florida Building Code, Building, Chapter 20 Aluminum (Sections 2002.3, 2002.4 and 2002.7), UpCodes / ICC Florida Building Code
- 2023 Florida Building Code, Building, Chapter 16 (Table 1604.5 and Section 1609.4), UpCodes / ICC Florida Building Code
- Aluminum Structures (PRAS), Collier County Growth Management
- Formal Interpretation, residential masonry reinforcement (8th Edition 2023 FBC), Collier County Building Plan Review & Inspection
- Tropical Cyclone Climatology, NOAA National Hurricane Center
- Permit Information Post-Hurricane, Collier County Growth Management
- 44 CFR 59.1 Definitions, Cornell Legal Information Institute
- Residential Pool or Spa, Charlotte County Community Development
- Pool/Spa (Private) permit checklist, City of Naples Building Department
- Chapter 515 Residential Swimming Pool Safety Act, Florida Legislature (flsenate.gov)
- Building, City of Punta Gorda
- Building Permit Fee Structure, City of Punta Gorda
- Do I Need a Permit brochure, Village of Estero
- Building Services, City of Marco Island
- Naples, Florida, Wikipedia

